Ensuring the proper torque specs for mounting modules to racking is a pain point on nearly every job. Racking manufacturers call out exact torque values, but most crews are still using standard drills or impacts and hoping “three ugga-uggas” was close enough.

This manual adjustable torque limiting cordless drill uses a mechanical clutch to hit low torque values accurately and repeatably. Set your torque, pull the trigger, and when the clutch slips you know you are on spec. Goodbye three ugga-uggas, hello effortless installs.

AVAILABLE IN TWO CONFIGURATIONS

Both are compatible with the Milwaukee® M18 Red Lithium battery (battery not included).

Pistol Grip

• Torque range: 2.4–8.8 ft-lbs (3.2–12 Nm)

• Output: 1/4" hex quick release

• Speed: 70–700 rpm (min/max)

• Ideal for general module clamp and hardware tightening where you have good access to the fastener

Right Angle

• • Torque range: 6.2–15.5 ft-lbs (8.3–21 Nm)

  • Output: 3/8" square drive

  • Speed: 36–360 rpm (min/max)

  • Ideal for tight or hard-to-reach areas, such as under modules or near obstructions

FEATURES

• Manually adjustable mechanical torque clutch for precise low torque settings
• Cordless design using Milwaukee® M18 batteries already on most solar job sites
• Lightweight, ergonomic design to reduce operator fatigue on large arrays
• Pistol grip and right-angle options to match different racking layouts and access needs
• Smooth, predictable clutch engagement to reduce cross-threading and rework
• Contactless electronic switch shuts off tightening rotation when required torque is reached
• Built-in LED work light 
• Operator Status Light provides batch count status
• Low battery shut off to prevent under-torqued fasteners
• Reduce Operator Error with pre-set torque ok/ not ok green and red lights
• RPM speed control 
• Optional one-on-one virtual tool training provided as needed

SPECIFICATIONS

• Power source: Milwaukee® M18 Red Lithium battery (not included)

• Pistol grip torque range: 2.4–8.8 ft-lbs (3.2–12 Nm)

• Pistol grip speed: 70–700 rpm

• Right angle torque range: 6.2–15.5 ft-lbs (8.3–21 Nm)

• Right angle speed: 36–360 rpm

• Accuracy: CM > 1.67 within a ±10% tolerance range (meets ISO 5393 requirement)